Electrician Hand Tools

Select and use hand, power tools and electrical devices relevant to construction electrical works

1. Assistant Electrician (NSQF Level – 3) Select and use hand, power tools and electrical devices relevant to construction electrical works Assistant Electrician (NSQF Level – 3) SECTOR: CONSTRUCTION SUB-SECTOR: REAL ESTATE AND INFRASTRUCTURE OCCUPATION: CONSTRUCTION AND ELECTRICAL WORKS REF. ID: CON/Q0602 NSQF LEVEL: 3 Sl no:2

2. Electrician Hand Tools It is important that the electrician uses proper tools for his work. The accuracy of workmanship and speed of work depend upon the use of correct tools. If the tools are properly used, and maintained, the electrician will find the working efficiency increases and the skills becomes a work habit. Listed below are the most commonly used tools by skilled electrician.

3. Line Tester This helps to check for the presence of the electricity in the conductor

4. Screw Driver It is use for screw tighten and loosening

5. Philip Screw Driver It is use for screw tighten and loosening

6. Combination Plier It is used for cutting wire as well as holding objects

7. It is used for cutting wire Side cutting Plier

8. Nose Plier It is used for holding deep objects and wire cutting

9. Wire Stripper It is used for cutting wires

10. Automatic Wire Stripper This helps to cut the wire without damaging the conductor

11. Electrician Knife It is used to remove wires insulation

12. Metal files It is used to grind and smooth

13. Claw Hammer It helps in hitting the nails as well as plucking the nails

14. Sledge Hammer It is used for beating and fating hard objects

15. Ball Peen Hammer It is used for hitting small nails

16. Cross Peen Hammer It is used for bending metal sheets as well as for nailing

17. Rubber Hammer It is used for motor winding

18. Fiber Hammer It is used for motor winding

19. Hack Saw Blade & Frame It is use for cutting PVC and Metal pipes

20. Tenon Saw It is used for cutting wooden box

21. Firmer Chisel It is used to make holes in wood

22. Crimping Tool A crimping tool is a device used to conjoin two pieces of metal by deforming one or both of them in a way that causes them to hold each other. The result of the tool's work is called a crimp.

23. Bench Vice This helps to stabilize the material

24. Pipe Vice Its use hole PVC or Metal Pipe Helps keep the pipes firm

25. Cold Flat Chisel It is used to make slot on wall It is used to make tiles on the walls

26. Rawl plug tool It is used to make holes on the walls

27. Center Punch Tool It is used to make pilot hole to metal It is used to make pilot holes in metal

28. Pipe Bending Spring It is used to bent PVC pipe

29. Cable Puller It is used to pull the wire through the pipe

30. Angle Grinder It is used to cut metal and PVC pipes

31. Drilling Machine It is used to make hole on the wall and concrete

32. Drilling Machine wireless It is used to make hole on the wall and concrete

33. Wall Cutting Machine It is used to cut wall and ceiling

34. Soldering Iron It is used to weld two wires and components

35. Measuring tape It is used to measure length and width

36. Plumb Bob It is used for marking vertical lines on the wall.

37. Standard wire gauge It is used to measure wire gauge

38. Torpedo Level It is used to level switch board and pipes.

39. Micro Meter It is used to measure wire gauge

40. Vernier Caliper It is used to measure length of objects

41. Double ended spanner It using tighten and loosing the nut and bolts

42. Ring Spanner It using tighten and loosing the nut and bolts

43. Monkey Spanner It using tighten and loosing the nut and bolts

44. END