Febrian Nug_Presentation_XII MEKA B.pptx

Pelaporan PKL

1. RESULT PRESENTATION PRESENTED BY FEBRIYAN N MECHATRONICS TEMBARAK VOCATIONAL SCHOOL 2024

2. SKILL COMPETENCE EXAM elektro pneumatic progammable logic controller

3. PROGAMMABLE LOGIC CONTROLLER (PLC)

4. PLC PLC is a microprocessor used for automation of industrial processes such as monitoring and controlling machines in a factory assembly line.

5. TERMINAL A terminal is the point where the conductors of a component, device, or network terminate.

6. PSU (POWER SUPPLY UNIT) PSU is a component used to supply or provide electrical power to one or more devices.

7. SENSOR PHOTOELECTRIC A photoelectric sensor is a tool used to detect the presence of an object which is usually solid.

8. SENSOR PROXIMITY INDUKTIF Inductive proximity sensor is a distance sensor that is used to detect the presence of metal, both ferrous metals and non-ferrous metals.

9. PUSH BUTTON A push button is a switch that will only connect two or more points when the button is pressed and when the button is not pressed it will disconnect two or more points in an electronic circuit.

10. CYLINDER A pneumatic cylinder is a mechanical device that uses compressed gas to generate force in a reciprocating linear motion

11. MCB MCB is a fuse replacement security device that is equipped with a better control system.

12. SOLENOID VALVE A solenoid valve is a valve that is controlled by AC or DC current through a coil/selenoid.

13. AIR SERVICE UNIT AIR SERVICE UNIT is a device for controlling air pressure which will be distributed to the pneumatic system.

14. CONVEYOR A conveyor is a mechanical system that has the function of moving goods from one place to another. Conveyors are widely used in industry for the transportation of large quantities of goods and continuously.

15. HOW TO NETWORK WORKS WHEN S1 DETECTS AN OBJECT AND A BUTTON IS PRESSED, THE MOTOR ACTIVATES AND STARTS THE CONVEYOR. WHEN S2 DETECTS A METAL OBJECT, THE CONVEYOR STOPS FOR A FEW MOMENTS, THEN THE KKA 5/2 SINGLE SOLENOID ACTIVATES, THE CYLINDER ADVANCES, AND THE CONVEYOR RESUMES RUNNING. THE METAL OBJECT FALLS TO THE SIDE THEN S3 READS THE OBJECT SO THE CYLINDER REVERSES AND THE CONVEYOR STOPS. WHEN AN OBJECT OTHER THAN METAL TRAVELS ON THE CONVEYOR, S2 WILL NOT DETECT IT SO THE OBJECT CONTINUES TO TRAVEL PAST THE CYLINDER AND FALLS AT THE END OF THE CONVEYOR. THEN S4 DETECTS THE OBJECT SO THE CONVEYOR STOPS AND THE PROGRAM ENDS.

16. ELEKTRO PNEUMATIC

17. Start and release Awards To create your own, choose a topic that interests you. To create your own, choose a topic that interests you. Events To create your own, choose a topic that interests you. New products release To create your own, choose a topic that interests you. TOOLS USED IN ELECTRO-PNEUMATIC CIRCUITS

18. ELEKTRO PNEUMATIC WHEN THE BUTTON IS PRESSED IT WILL ACTIVATE 1Y1 AND CYLINDER A TO MOVE FORWARD TO THE MAXIMUM AND ACTIVATE S2 AND CYLINDER A TO GO BACK TO A MINIMUM AND ACTIVATE S1 AND AT THE SAME TIME S3 IS ACTIVE CAUSING CYLINDER B TO MOVE FORWARD AND HIT THE LIMIT SWITCH CYLINDER B GOES BACKWARDS

19. THANK YOU listening my presentatiton OFFICE ---- www.febri.com smk n tembarak