Next generation wireless communication

AbhishekKushwaha46 2,472 views 28 slides Apr 17, 2019
Slide 1
Slide 1 of 28
Slide 1
1
Slide 2
2
Slide 3
3
Slide 4
4
Slide 5
5
Slide 6
6
Slide 7
7
Slide 8
8
Slide 9
9
Slide 10
10
Slide 11
11
Slide 12
12
Slide 13
13
Slide 14
14
Slide 15
15
Slide 16
16
Slide 17
17
Slide 18
18
Slide 19
19
Slide 20
20
Slide 21
21
Slide 22
22
Slide 23
23
Slide 24
24
Slide 25
25
Slide 26
26
Slide 27
27
Slide 28
28

About This Presentation

5th generation to wireless technology. Upcoming technology in future. Go throw it.


Slide Content

Next generation Wireless Communication Name: Abhishek Kushwaha College name: ABSSIT Branch: C.S.E Course: B-Tech

Content Lets us look back to previously wireless communication Introduction to next-G wireless communication What is 5g? Improvement on 5G Improvement of technology in 5G(millimeter waves, small cell network and beamforming)/working of 5G Features of 5G Conclusion

Generation of wireless communication 1 G (First Generation) 2 G (Second Generation) 3 G ( Third Generation) 4 G (Fourth Generation) Next G ( Fifth Generation i.e 5 G ) Continue……..

Generation of wireless communication 1G ( First Generation in 1981) It has a. NMT(NORDIC Mobile Telephone) It is an analog system for mobile communication. NMT is the first fully automatic cellular  phone   system and service on October 1, 1981. b. TACS(Total Access Communication System) It  is an analogue mobile communications system used in the U.K  Its prime differences are the radio frequencies, the radio channel bandwidth and the data signaling rates . TACS is an analogue FM system operating in the 890-915 MHz / 935-960 MHz band. Based on Analog system and Analog signals

c. ETACS(European Total Access Communication System ) In ETACS additional downlink (range 917MHz- 933 MHz) and uplink (890 MHz – 915 MHZ) frequencies were allocated . 320 additional channels were allocated to both the cellular operators for speech channels. NMT TACS ETACS

B. Drawbacks of 1G The main drawbacks of this system were limited capacity because of inefficiencies of analog voice transport and limited services because of analog signaling. Due to these drawbacks ETACS was replaced by other more efficient systems like GSM (Second Generation of wireless telecommunication technology).

B. Second Generation (2G)   It is based on GSM or in other words global system for mobile communication .   It was launched in Finland in the year 1991. GSM technology was the first one to help establish international roaming . Second generation technologies are either time division multiple access (TDMA) or code division multiple access (CDMA). TDMA allows for the division of signal into time slots . CDMA allocates each user a special code to communicate over a multiplex physical channel .   Different TDMA technologies are GSM, PDC( personal digital cellular technology ), iDEN ( integrated digital enhanced network   ), iS-136 . CDMA technology is IS-95.

TDMA CDMA device

Drawbacks of 2G The  digital signals could be weak if there is no network coverage in any specific area. The digital signal has jagged decay curve. The downloading & uploading speeds available in 2G technologies are up to 236 Kbps. The downloading & uploading speeds available in 2G technologies are up to 236 Kbps

Third Generation(3G) Bandwidth High bandwidth—the measure of transmission capacity—is one of the selling points of 3G . While the maximum bandwidth for a stationary 3G device—according to Silicon Press—is 2.05 megabits (Mbps), when you are moving slowly (such as walking), this drops to 384 kilobits (Kbps). 3G technologies make use of TDMA and CDMA(Code Division Multiple Access). 3G (Third Generation Technology) technologies make use of value added services like mobile television, GPS (global positioning system) and video conferencing . The basic feature of 3G Technology (Third Generation Technology) is fast data transfer rates . 3G technology is the modified form of second generation it is better to say that all the best features of different versions of 2nd generation are combined into third generation . Resultantly 3G Technology is known as Smartphone with high data transfer rate, WiFi hotspots connectivity and multimedia features.

Packet switch domain Circuit switch domain 3G network Architecture RNC(Radio Network Controller) IMS(IP Multimedia System) MSC(Mobile Switching Center) SGSN(Service GPRS support node) GMSC(Gateway mobile switching center) node1 node2 RNC SGSN MSC GGSN GMSC Radio Access Network(RAN) Bus station IMS IP network Circuit switch network

4G/LTE network (Fourth Generation Network)  4G network is heading towards a new dimension in the field of wireless technology . Its first step is the provision of quality service to its clients . Second point is the refine signals for reliable communication with no fear of data loss . 4G network provide service for audio/visual and other multimedia service with ultimate speed of 100 megabytes per second. It also facilitate roaming everywhere. It works on high frequency of bandwidth.

Based feature of 4G Two technologies that are supposed to be based features of 4G are WiMAX(Worldwide interoperability of Microwave Access) Connecting to WiMAX network, this information first processed to the internet home and then spread widely. Most of the time this transmission happens very fast problems arise in case of spectrum, bandwidth and data . This WiMAX technology has a high speed of data transfer rate with additional capacity for the subscribers and ready to carry big amount of data. Continue……..

LTE (Long Term Evolution ) LTE is developed on radio waves technology . This not only increases the speed but also the amount of data allowed through the same bandwidth and results into lower cost . LTE is considered to be promising high data transfer speed .   LTE is using MIMO (Multiple input multiple output) able to send and receive huge data  . Continue……

Some devices which works on 4G WiMAX device LTE devices

Limitations of 4G Operating area Still don’t reached to the rural areas and in the cities of many buildings. Cost( Expensive) Poor and average get difficult to buy this 4G devices. According to the requirement of people though the ultimate speed of 4G is 100 mbps, their demand increases to more than this which exists the fifth generation wireless communication i.e next generation wireless communication.

Why we need 5G? Internet of things Autonomous driving Virtual reality Perfection in artificial intelligence etc.

Introduction to next-G wireless communication Next-generation wireless (NextG) involves the concept that the next generation of wireless communications will be a major move toward ubiquitous wireless communications systems and seamless high-quality wireless services . This presents the concepts and technologies involved, including possible innovations in architectures, spectrum allocation, and utilization, in radio communications, networks, and services and applications. These include dynamic and adaptive systems and technologies that provide a new paradigm for spectrum assignment and management, smart resource management, dynamic and fast adaptive multilayer approaches, smart radio, and adaptive networking .

What is 5G? 5G is assumed as the perfection level of wireless communication.   All the previous wireless technologies are entertaining the ease of telephone and data sharing but 5G is bringing a new touch and making the life real mobile life. Monitor any space of the world from anywhere, observe space and watch TV channels at HD clarity in our mobile phone without any interruption. It will provide super and perfect utilization of cellular communication in future.

Some devices on which 5G works i phone 5g Technology

How 5G works?

5G is based on following 3 technologies Millimeter wave The devices which we are using nowadays that works under 6 GHz. Due to crowded in this range 5G uses new spectrum(increase in bandwidth) 30-300 GHz is taken which will be based on millimeter waves. Apple is working on their technology under 28 GHz to 39 GHz Continue…..

2. Small cell network Limitation of millimeter wave is, it cannot travel through any obstacles such as buildings , houses and cloud and plants absorb it. For this purpose small cell network is used. To remove this limitation 5G uses 1000 of Small cell network to boost the signal at anywhere.

3. Beamforming Today’s cell tower which are used in our locality, they are omnidirectional means their signal transmit in 360 degree direction which results more interference due to which proper network is not achieved to everyone. By using this beamforming cell towers can be able to provide the network to specific users.

Improvement on 5G One to 10Gbps connection to the end-points in the field. One millisecond end to end round trip delay. 1000x bandwidth per unit area. 10 to 100x number of connected devices. (Perception of ) 99.999 percent availability. (Perception of ) 100 percent coverage. 90 percent reduction in network energy usage. Up to 10 -year battery life for low power, machine type devices.

Features of 5G The advanced billing interfaces of 5G technology makes it more attractive and effective . The uploading and downloading speed of 5G technology touching the peak . 5G technology is providing large broadcasting of data in Gigabit which supporting almost 65,000 connections. The 5G technology network offering enhanced and available connectivity just about the world

Conclusion Though 5G is supposed to be exist in 2020, because of its features and improvement on various technology, public are curious to get its experience. If it come in exists, living standard of people will touch the peak. Because of its facilities people will become lazy on their work and it will be the great disadvantage of this generation.

Thank you For your concentration