ARDUINO BASED ACCIDENT PREVENTION SYSTEM USING EYE BLINK.pptx

gjgd

1. EYE BLINK SENSOR AND ARDUINO

2. ABSTRACT This paper aims to create a framework to keep the car safe and secure through critical activity

3. If we make all vehicles with an automatic safety system that gives the driver a high level of protection, an alarm will also be issued The device has an installed a eye blink sensor. Once the driver has started the engine, the sensors automatically detect the blink of eye On this device the output of the sensor is provided for comparison with ARDUINO When the value reaches the set level, the buzzer automatically vibrates, the LED glows, and the car stops automatically when eye blink sensor receives a signal from the transmission module.

4. INTRODUCTION The failure of drivers in any vehicle incidents is a very important part of the dangerous problem facing the community

5. Various things involved in car crashes such as high speed, sleep while driving other distractions such as texting while driving, talking to others, playing with children, etc.

6. About 1374 people die every day, and about 400 people die. Approximately 57 road accidents and 17 deaths per hour as a result of motor vehicle accidents In car accidents, 54.1 percent are between the ages of 18 and 34

7. The details of causes for the Road accidents by Government of India is summarized as follows. Due to Driver (77%) Weather Condition (1%) Vehicle Condition (2%) Pedestrian’s fault (2%) Cyclist’s Fault (1%) Road Condition (2%) Other (14%)

8. We focused on this issue using the eye twitch sensor to introduce a car accident prevention program

9. LITERATURE SURVEY Accidents due to rash driving and drowsiness are more inclined and need to be controlled To control these type of accidents monitoring of the surrrounding is required The development of technologies for detecting the drowsy state of the driver is a big challenge in the field of accident avoidance system Several literature paper have been studied and analysed for the syatem design Sleep and drowsy detection system is used to monitor the driver and alert them to wake the driver from sleep in order to avoid the possibility of collision

10. One of the method is by fixing a infrared sensor in a wearable spectacle which monitors the eye blink rate of the driver who wears the spectacle This system alerts the driver from the possibility collision as the driver wear the glass while driving the car If the eye of the driver is closed for the particular time i.e., for example take more than 3 seconds then the infrared sensor sense the eye blink rate and send the signal to the buzzer There are various methods for this drowsy detection

11. Then the buzzer gets on Additional to the buzzer we can also keep a vibrational motor in the driver seat which will alert the driver from the drowsiness condition

12. NOVELITY We added to the project that the vehicle stops automatically when the driver sleeps or blinks eye

13. FIG: Old Connection of the Block dig

14. FIG: New Connection of the Block dig

15. SIGNIFICANCE To a void the accident To Decrease in rate of fault accident It uses a simple ARDUINO sensor to detect if the person’s eye is closed and the corresponding data received can further be processed by any logic as requird for the application