Circuit theory thevenin theorem

Thevenin's Theorem for DC Network

1. CIRCUIT THEORY
THEVENIN’S THEOREM
SYED HASAN SAEED
Wednesday, July 24, 2019 1syed hasan saeed

2. THEVENIN’S THEOREM D.C. NETWORK
STATEMENT: Any linear, active, bilateral dc network having a number of
voltage sources and/or current sources with resistances can be replaced
by a simple equivalent circuit having single voltage source (V
th) in series
with a single resistance (R
th).
Where (V
th) is the open circuit voltage known as Thevenin’s equivalent
voltage across the terminal a-b.
(R
th) is the Thevenin’s equivalent resistance viewed back into the network
from terminal a-b.
Note: independent voltage sources are short circuited and independent
current sources are open circuited. Dependent sources will remain in the
circuit.
Wednesday, July 24, 2019 syed hasan saeed 2

3. PROCEDURE FOR CONVERTING ANY CIRCUIT INTO
THEVENIN’S EQUIVALENT CIRCUIT AND ITS
CALCULATIONS:
Step 1: Identify and temporarily remove the resistance (load resistance R
L) through
which current is required. Suppose these terminals are label as a-b. Therefore a-
b is the open circuited.
Step 2: Find the voltage across the terminal a-b by applying KCL, KVL, Ohm’s
law or Superposition principle. This voltage is the open circuit voltage (V
oc) and
it is known as Thevenin’s equivalent voltage (V
th).
Step 3: Set all voltage Sources short circuited and Current Sources open circuited
Step 4: Calculate the resistance as “seen” through the terminals a-b into the
network. This resistance is known as Thevenin’s equivalent resistance (R
th).
Step 5: Replace the entire network by Thevenin’s equivalent voltage (V
th) in series
with Thevenin’s equivalent resistance (R
th).
Step 6: Reconnect the previously removed resistance (load resistance R
L) to this
circuit.
Wednesday, July 24, 2019 syed hasan saeed 3
THEVENIN’S THEOREM D.C. NETWORK

4. Step 7: Calculate the Current through load resistance R
L
Wednesday, July 24, 2019 syed hasan saeed 4
THEVENIN’S THEOREM D.C. NETWORK
V
th
R
th
R
L
Linear, Active,
Bilateral
Network
R
L
a
b
b
a
I
L
I
L
Thevenin’s Equivalent
Network
Fig. (1a)
Fig. (1b)

5. EXAMPLE: Find the current, voltage drop and power loss across the 5 ohm resistor
by applying the Thevenin’s theorem (as shown in fig. 2)
SOLUTION: STEP 1: Calculation of V
th
Remove 5 ohm resistor
V
th
Wednesday, July 24, 2019 syed hasan saeed 5
THEVENIN’S THEOREM D.C. NETWORK
12 V
2 ohm 3ohm
4ohm 5ohm
Fig. 2
5V
12 V
2 ohm 3ohm
4ohm
5V
a
b
I
Fig. 2a

6. Apply KVL in LHS mesh:
12 -2I -4I = 0
I = 2A
Apply KVL in RHS mesh :
-V
th+ 4I -3I -5 = 0
Put I = 2A
V
th= -3V
STEP 2: Calculation of R
th
Wednesday, July 24, 2019 syed hasan saeed 6
THEVENIN’S THEOREM D.C. NETWORK
2 ohm 3ohm
4ohm
R
th
a
b
2 and 4 ohm resistance are in parallel and this combination is in series with 3 ohm
resistor. 

 33.43
42
4*2
R
th
Fig. 2b

7. THEVENIN’S THEOREM D.C. NETWORK
STEP 3: Draw the Thevenin’s Equivalent Circuit
STEP 4: Connect 5 ohm resistor in the circuit as shown in fig.2d and calculate “ i”
Wednesday, July 24, 2019 syed hasan saeed 7
V
th= 3
R
th= 4.33 ohm
Fig. 2c
V
th= 3
R
th= 4.33 ohm
R
L= 5 ohm
i
: Thevenin’s Equivalent circuit
Fig.2d0.322Ai
A322.0
33.9
3
533.4
3
RR
V
i
Lth
th







8. STEP 4: Calculation of Voltage drop across 5 ohm resistor :
STEP 5: Calculation of Power loss across 5 ohm resistor :
Wednesday, July 24, 2019 syed hasan saeed 8
THEVENIN’S THEOREM D.C. NETWORK1.62V5*0.322R*iV
5ohm
 0.518w5*(0.322)R*(i)LossPower
22


9. THANK YOU
[email protected]
[email protected]
hasansaeed872726549.wordpress.com
saeed.moodlecloud.com
syedhasansaeed.gnomio.com
Wednesday, July 24, 2019 syed hasan saeed 9