Clipper circuit

4,369 views 15 slides Aug 22, 2016
Slide 1
Slide 1 of 15
Slide 1
1
Slide 2
2
Slide 3
3
Slide 4
4
Slide 5
5
Slide 6
6
Slide 7
7
Slide 8
8
Slide 9
9
Slide 10
10
Slide 11
11
Slide 12
12
Slide 13
13
Slide 14
14
Slide 15
15

About This Presentation

This Slide is about simple Clipper Circuit.


Slide Content

Bangladesh Army University of Engineering & Technology Presented by Md. Mahbub Hasan Id: 151012 Department: EEE

Presentation on Clipper Circuit

Outline Clipper Circuit . Types Of Clippers Circuits. Unbiased Positive Clipper Circuit. Unbiased Negative Clipper Circuit. Biased Positive Clipper Circuit. Biased Negative Clipper Circuit. Observing Input & Output signal Using Pspice . Given Circuit Diagram View Schematic Circuit Graph . Simulation Process from Video Capture.

Clipper Circuit In electronics, a  clipper  is a device designed to prevent the output of a  circuit  from exceeding a predetermined voltage level without distorting the remaining part of the applied waveform . Clipping circuits are also called  slicers ,  amplitude selectors  or  limiters.

Types of Clipper Circuits

Unbiased positive Clippers Positive clippers are used to clip positive portions of the input signal and allow the negative portions of the signal to pass through. Figure below shows that the positive cycle is completely clipped off by the clipper.

Unbiased Negative clippers Negative clippers are used to clip Negative portions of the input signal and allow the positive portions of the signal to pass through Figure shows that the negative cycle is completely clipped off by the clipper.

Biased series positive clipper A biased clipper comes in handy when a small portion of positive or negative half cycles of the signal voltage is to be removed. When a small portion of the positive half cycle is to be removed, it is called a biased positive clipper. The circuit diagram and waveform is shown in the figure below

Biased series negative clipper A biased clipper comes in handy when a small portion of positive or negative half cycles of the signal voltage is to be removed. When a small portion of the negative half cycle is to be removed, it is called a biased negative clipper. The circuit diagram and waveform is shown in the figure below

Observing Input & Output signal Using Pspice

Given Circuit Diagram

View Schematic Circuit Graph

References www.en.Wikipedia.org/wiki/Clipper_(electronics) www.allaboutcircuits.com www.daenotes.com www.circuitstoday.com/diode-clippers www.circuitsgallery.com Book Reference Electronic Devices and Circuit Theory - Robert L Boylestad . Louis Nashelsky

Any Query!?

THANK YOU