Design of a Smart GSM based Vehicle Anti-theft Security System using Vibration sensor and Arduino

anti theft security system using vibration sensor and arduino

1. Page 1 /11 Presented by: Department of Electrical & Electronic Engineering INDEPENDENT UNIVERSITY, BANGLADESH EEE315L Project Lab Design of a Smart GSM based Vehicle Anti-theft Security System using Vibration sensor and Arduino Supervisor: Abdullah Al Noman

2. Introduction Background, Motivation and Objectives Proposed System Design & Simulation Results and Analysis Conclusion Outline Page 2 /11

3. Introduction Fig1: Motor vehicle theft Security as primary concern 1,061 cases in 2006 Detect theft Alert the user in few seconds Low power usage Page 3 /11

4. Background, Motivation and Objectives Roughly 1 million vehicles are being stollen. The loss cost estimation is 6.4 billion dollar. Conventional ways e.g. LoJack , ProScout , TravelEyes2 are expensive. Not up to the mark. Early prevention. Vibration sensor is more sensitive. Page 4 /11

5. Table of Components Component Model Vibration Sensor SW420 Arduino Uno Rev3 LCD LM016L GSM Sim900D Page 5 /11

6. Page 6 /11 Proposed System Fig2: Functional block diagram showing the interaction between the systems of the proposed design.

7. Design & Simulation Fig3: Complete Circuit Diagram of the proposed System Page 7 /11

8. Flow diagram of proposed system Page 8 /11

9. Results and Analysis Turning on security system Sending SMS SMS to owner Page 9 /11

10. Conclusion This project provides reliable security system for a vehicle which helps in safeguarding the vehicle. It involves wireless communication for real time monitoring of the vehicle with low power consumption. Page 10 /11

11. Any questions, comments or suggestions? Page 11 /11