Reil, jaipur

reil, jaipur

1. A PRACTICAL TRANING PPT, ON REIL, JAIPUR By: Garvita Jain

2. Company profile About REIL Departments in REIL Agro dairy division Renewable Energy division Conclusion Contents

3. Company Profile

4. About REIL Establishment on 12 th july 1981 situated at the kanakpura industrial area, jaipur joint venture b/w the govt. of india (51%) & govt. of rajasthan (49%)

5. Departments IN REIL Industrial Electronics and Information Technology Division

6. Agro dairy division Started operations in this division at 1982

7. Electronic Milk Tester(EMT) Optical milk analyser Data Processor-Electronic Milk Tester(DPEMT) Milko Scan Agro Dairy Products

8. It is an instrument which is used for the measurement of fat percentage in milk. Based on photometric measurement or light scattering principle. quicker, reliable and economical method of fat of milk testing. Electronic Milk Tester

9. Runs on mains or battery Measuring range- 0-13% fat Capacity- 120-150 samples per hour Cheapest and the easiest method of milk testing EMT FEATURES

10. PROCEDURE

11. Can measure protein, lactose & SNF alongwith the fat content in a milk sample High measuring speed It give result in approximately in 90 seconds . Saves time Greater data security Reduces manual data entry Milko scan

12. OPTICAL MILK ANALYSER Performs 150 tests/hour Displays SNF% also Result is independent of sample temperature and air bubbles Low power consumption

13. Solar Photovoltaic cells are made up of Silicon These are used to convert solar energy into electricity. These are made up of array of different solar cells. A solar cell generates approximately 0.5 volts. SPV Modules

14. These material absorb the sunlight , thereby knocking out loose electrons from their atoms, allowing the electrons to flow through the material to produce electricity. This process of converting light (photons) to electricity (voltage) is called the Photovoltaic (PV) Effect This energy is stored in batteries and can be used in night hours Working principle

15. Flow chart

16. Tabbing process of making terminals of a bare cell by soldering copper strips to the bus bar.

17. A row of cells is made by connecting positive surfaces of one cell to the negative surface of another cell. 17 Stringing Process

18. In this process, rows of SPV cells are connected in series to get the desired power rating. 19 Lay Up

19. Solar cells are laminated between back sheet and toughened glass. Then the module formed is placed inside the laminator for lamination followed by an oven for curing. Lamination & Curing

20. This frame provides structural support for mounting and shock resistance. 21 Channelling

21. Have no moving parts. The fuel (sunlight) free. No noise pollution or any other type of pollution. Requires minimum maintenance. Have long lifetimes (up to 20 years). Advantages

22. High Cost. Large Surface Area. Doesn’t work at night. Climate sensitive. Disadvantages

23. Conclusion Made me learn the practical aspects of engineering. Gave me experience of working in a professional environment. Learnt adjusting myself to the hectic schedule and workload.

24. 25