INSPECTION of Hand Toolssssssssssss.pptx

tl3

1. Good Day

2. Inspect Hand Tools, Drawing Instruments, Equipment and Paraphernalia

3. It is your turn to pen down your thoughts by reading and understanding each statement carefully. Write T if you think the statement is TRUE and F if you think the statement is FALSE on your test notebook. 1. All tools and equipment must be placed in a clean and dry place. 2. Clean tools and equipment work more efficiently

4. 3. The work area must always be kept untidy and dusty. 4. Cleaning the tools after use is highly recommended. 5. Any devices that show any defects should be disposed of.

5. Inspection of hand tools Inspection is defined as the act of looking at something to discover important information about a characteristic, quality, or condition.

6. In technical drafting, inspection is done to verify or check that all the needed tasks for hand tool production are free from damage, defect, or loose joints. If tools are in good condition, proper and consistent production can be ensured. Any tool that shows a defect or damage should be immediately repaired or replaced to avoid the risk of creating defective products.

7. 1. Prioritize safety • Ensure that the workplace is safe for you and the tools. • Keep any liquid away from the materials. • Wear the appropriate Personal Protective Equipment

8. 2. Inspect hand tools • Prepare a checklist of hand tools. • Check the condition of each hand tool. • Accomplish the different forms.

9. Compile Inspection report • Organize the accomplishment report. • Validate the content of the accomplishment report • Submit the report to the authorized person

10. Procedures in Receiving and Storing Tools and Materials Inspection Department has the following functions unloading and unpacking incoming materials checking quantities received against the shippers packing list identifying goods received with descriptions on the purchase order

11. preparing a receiving report • notifying the purchasing department of descriptions discovered • arranging for inspection when necessary • notifying the accounting office of any damage in transit • routing accepted materials to the appropriate manufacturer’s location

12. Technical Pen A pen is used for inking mechanical lines Drafting Table The main purpose is to provide you a place where you can fasten your drawing paper.

13. Auto CAD Computer A high technology machine for drawing purposes only.

14. A. Drawing Tools Pencil, compass, divider, eraser, ruler, t- square, etc. B. Measuring tools Tape rule, foot ruler, protractor, T square, triangles CLASSIFICATION OF TOOLS

15. Directions : Give the classification of each drafting tool below, if it is used for DRAWING or MEASURING,.

16. Assignment Practice drawing horizontal and vertical lines