Isolation facility in Hospital

sharrygajuryalnepal 12,915 views 38 slides Apr 10, 2015
Slide 1
Slide 1 of 38
Slide 1
1
Slide 2
2
Slide 3
3
Slide 4
4
Slide 5
5
Slide 6
6
Slide 7
7
Slide 8
8
Slide 9
9
Slide 10
10
Slide 11
11
Slide 12
12
Slide 13
13
Slide 14
14
Slide 15
15
Slide 16
16
Slide 17
17
Slide 18
18
Slide 19
19
Slide 20
20
Slide 21
21
Slide 22
22
Slide 23
23
Slide 24
24
Slide 25
25
Slide 26
26
Slide 27
27
Slide 28
28
Slide 29
29
Slide 30
30
Slide 31
31
Slide 32
32
Slide 33
33
Slide 34
34
Slide 35
35
Slide 36
36
Slide 37
37
Slide 38
38

About This Presentation

Isolation facility- Introduction/ History/background and planning and designing


Slide Content

DR.SHARAD H. GAJURYAL
JUNIOR RESIDENT,MD(HA)
BPKIHS,NEPAL
ISOLATION FACILITY

Background/History
•Contagious disease has challenged society
throughout human history.
• In the 18th and 19th centuries, smallpox led to
smallpox hospitals in some large urban
communities. At the same time, citizens lived with
the fear of outbreaks of typhus, typhoid fever,
diphtheria, scarlet fever and influenza.
• The effectiveness of isolation was often limited due
to the lack of knowledge of the cause and
transmission of these infectious diseases

The germ theory of infectious disease was
formulated during the second half of the 19th
century.
In the absence of specific treatment, isolation
became the principle strategy to prevent the
transmission of contagious disease.

•The Ontario Public Health Act in 1884 provided for
the expropriation of land for isolation hospitals and
required separate facilities for smallpox.
•The Nickle Wing of the Kingston General Hospital,
one of the earliest isolation facilities in Canada,
served the community from 1892 until 1922.

The introduction of public health defenses included
improved sanitation and safe water to prevent
cholera and typhoid fever;
Vaccines that lowered the incidence of smallpox,
diphtheria, pertussis, tetanus, rubella, measles,
mumps and polio;
And the discovery of antibiotics to treat specific
infectious disease

Extrapolating from these dramatic advances, many
concluded that infectious disease could be prevented
or easily managed. During the 20th century, the
practice of isolation in hospital and the home
declined.

•In recent years, even developed countries have
discovered that they remain painfully vulnerable to
infectious disease.
•The re-emergence of antibiotic resistant organisms
such as staph aureus, c. difficile, and tuberculosis
particularly in the immune deficient contribute to
nosocomial infections in hospitals, nursing homes
and the community, while epidemics of cholera occur
due to failure of sanitary conditions.

•The emergence of mutations of the influenza virus
leading to pandemics such as the SARS outbreak for
which there is little or no specific treatment are
annual concerns.
•These infections again require isolation in hospital
and the community. The lessons learned in the 19th
century are particularly relevant to these present day
challenges

In 1969, The Joint Commission on Accreditation of
Health Care Organisation (JCHAO) recommended
for the need of isolation facility and infection control
committee in Hospitals.

Documents issued for Guidance of Isolation

Definition :- Isolation is the separation of a person
or a group of person infected or believed to be
infected with contagious disease to prevent spread of
infection in hospital setting.

•Types of Isolation :
•Source Isolation :AIIR ( Airborne Infection Isolation
Room) or negative pressure room.
•Protective Isolation : Positive Pressure Room
*It is considered inadvisable to mix accomodation for patients
requiring src isolation and protective isolation

•Source Isolation ( Most frequent Type ;Negetive
Pressure Room) – This type of isolation facility is
used to prevent spread of infection from the patient
to other patient and hospital Staffs .
•Patients with communicable disease who can pass
infections to others via airborne droplets are isolated
in this type of room. eg.:TB.SARS,H1N1

Protective Isolation : (positive Pressure Room)-
These type of isolation facility are meant to isolate
profoundly immune -compromised patients, such as
patient undergoing organ transplant, or oncology
patient receiving chemotherapy, HIV, etc.

Basic concept of Pressure

Planning & Designing
1.Requirement of Isolation Facility
Influenced by the pattern of clinical work and type of
specialist units
• 2.5% of total beds ,
•10-20% of Total ICU beds in ICU (1 per 5 bed)
•1 per 30 beds/100 bedded Hospital
•2. Area of Isolation Room – 22 Sq. m

Source Isolation Room requirements :
1.Negetive pressure maintained with or without ante room/
or bathroom.
2. More than 12 Air change per hour
3.Minimum leakage maximum 1 inch under the room door.
4.Air should be exhausted to outside (No recirculation) or
must pass through HEPA filter in case of recirculation.
5.Pressure sensor with alarm is recommended.
6.Pressure difference equal or more than 2 pascal.
With airlock ,degree of protection is about 10000 times that found
in an open situation

- +
- -
- -

The exhaust air should be drawn from low level exhaust duct approximately 150mm
above the floor

1- SMOKE TUBE TEST
2- TISSUE TEST A
THIN STRIP OF TISSUE SHOULD BE
HELD PARALLEL TO THE GAP
BETWEEN THE FLOOR AND
BOTTOM OF THE DOOR. THE
DIRECTION OF THE TISSUE‘S
MOVEMENT
WILL INDICATE THE DIRECTION OF
AIR MOVEMENT.
3-MANOMETER
Verifying Negative
Pressure

Protective Isolation Room
1.Positive pressure room in relation to
corridor with inside bathroom with
2.Pressure difference minimum 8 Pascal .
3.> 12 ACH is required .
4.Well sealed room.
5.Supply air must pass through HEPA filter.
6.Directed room airflow with air supply on
one side of the room that moves air across
the patient bed and out through an exhaust
on the opposite side of the room.

Protective Isolation Room requirements
1.Positive pressure room in relation to
corridor with inside bathroom with
2.Pressure difference minimum 8 Pascal .
3.> 12 ACH is required .
4.Well sealed room.
5.Supply air must pass through HEPA filter.
6.Directed room airflow with air supply on
one side of the room that moves air across
the patient bed and out through an exhaust
on the opposite side of the room.

3. Other requirement :
•Access to oxygen and compressed air ,
•Ante room,
•Wash room,
•Disposable crockery and cultery items ,
•Paper plastic Cups,
• speaking panel/ glass partitions to avoid direct
contact with visitors

Isolation cart
When a room used for isolation lacks the ante room
or lock chamber,an isolation cart is used which is not
taken inside the isolation room.

Physiological Stress of isolation
•Many patients with complete isolation from any
audible or visual indications of life outside impose
great psychological stress.
•Occasionally elderly patient subjected to prolonged
isolation have appeared to suffer from it .
•Children in isolation ward think they are being
punished, they have been rejected or unworthy.
•It is desirable for nurses to spend extra time in room.
•Mothers may also help to look after babies if
isolation procedures are shown to them.

Hierarchy of Infection Prevention and
Control Measures
PPE
Engineering Controls
Protects
only the
wearer
Elimination of Potential
Exposures
Administrative
Controls
Protects
most
people

Elimination of Potential
Exposures
•Example: patients with mild
influenza like illness stay home

Engineering Controls
Physically separates the employee from the
hazard
Does not require employee compliance to be
effective
Examples:
Physical barriers at Triage
Airborne infection isolation room for
patients with known or suspect
airborne infectious diseases

Administrative Controls/
Workplace Practices
Policies, procedures, and programs that
minimize intensity or duration of
exposure
Examples:
signs on door of an airborne isolation
room
triage, mask symptomatic patient
provide tissues/ masks/hand sanitizer
to public
Standard procedures/ behaviors in caring
for patients e.g. hand hygiene, HCW
vaccination

Administrative aspect in management of epidemics and
communicable disease
PPE should be readily available
Avaibility of appropriate medications and disposables and
life saving equipments has to be ensured
Proper BMW disposal should be carried out
In case of exposure to staff,prophylaxis has to be provided
by institue.
Information to the state authority to be provided about the
case.
Media has to be provided relevent disease information and
update without creating panic

Personal Protective Equipment
Lowest level of hierarchy - requires employee
compliance for efficacy
Means higher elements of hierarchy fail to
adequately protect employee
May involve use of gowns, gloves, eye/splash
protection or respirators
Last line of defense

Face Masks vs. N95 Respirators
Loose fitting, not designed
to filter out small aerosols
Place on coughing patient
(source control)
HCW should wear mask to
protect patient during
certain procedures (e.g.,
surgery)
 protect HCW
droplet precautions
Mask + goggles for
anticipated
spray/splash
Tight fitting respirator,
designed to filter the air
Protects the wearer
HCW should wear when
concerned about
transmission by airborne
route

THANK YOU FOR YOUR STERILE
ATTENTION !