WOOD AND SEASONING OF WOOD

ecat031 5,527 views 22 slides Mar 07, 2019
Slide 1
Slide 1 of 22
Slide 1
1
Slide 2
2
Slide 3
3
Slide 4
4
Slide 5
5
Slide 6
6
Slide 7
7
Slide 8
8
Slide 9
9
Slide 10
10
Slide 11
11
Slide 12
12
Slide 13
13
Slide 14
14
Slide 15
15
Slide 16
16
Slide 17
17
Slide 18
18
Slide 19
19
Slide 20
20
Slide 21
21
Slide 22
22

About This Presentation

These are the presentation slides about wood, seasoning of wood and also the prevention of wood


Slide Content

Topic

wood DEFINITION: “Wood is a porous and fibrous structural tissue found in the stems and roots of trees and other woody plants” It is an organic material a natural composite of cellulose fibers ( which are strong in tension). C lassification of wood. Hard wood Soft wood Fiber wood

HARD-WOOD: “Hard woods come from broad-leaved trees (deciduous trees that drop their leaves every year and produce seeds” Hardwood trees are very slow growing trees. Hardwood are usually much darker in colour . Hardwood is more expensive. Example: Walnut,Oar,Cherry,Ash etc SOFT-WOOD: “ Softwood comes from conifer trees (trees that have needle and do not produce seeds”

Softwood is cheap comparative to hardwood. Softwood has faster rate of growth. Softwood has low density. Example: Pine, R edwood etc. FIBER-BOARD: “Fiberboard is an expensive manufactured wood made from the breaking down of hard on soft woods into fibers which are then bonded together with wax, resin and heat to create a dense piece of wood.

CLASSIFICATION OF TREES 1.Endogenous Tree: One that grow inward in a longitudinal fibrous mass such as Banana, Bamboo, Palm and Cane. This steam of these trees is light and tough. 2. Exogenous Tree: One that grow outward by the addition of one concentric ring every year. like: Deodar, Pine, Shisham etc.

GENERAL CHARACTERISTICS OF WOOD Most important characteristic of wood is given below. 1 . Colour and Smell: Most trees are characterized by a typical colour and smell. Such as walnut wood is distinguished by its typical dark brown colour.

As regards smell, quite a few kinds of wood are immediately identified. 2. Specific Gravity: Wood is a very high material, its specific gravity being always less than 1 (that of water). Wood shows a good deal of variation in their specific gravity. 3. Moisture Content: All woods are poor to some extent .Further, all woods are hygroseopic

in nature. Moisture content of 12% - 15% of air-seasoned wood is considered quite safe for timber. 4. Grain : By grain it is understood that the arrangement and direction of grown of the wood elements (tracheids, fibers and vessels) in the wood.

5. SHRINKAGE AND SWELLING: The newly out wood loses moisture when subjected to drying artificially. on drying the wood under goes a shrinkage. Similarly, dry wood on getting rain method or wetted may undergo considerable swelling.

6. Strength: The most important fact about the strength of timber is that it is not the same in all direction. This is because wood is an anisotropic material, having different structure in different directions.

SEASONING OF WOOD DEFINITION: Wood seasoning is defined as : The removal of moisture that is present in the wood in its green state. Newly felled tree contain a considerable amount of moisture. If the moisture is not removed so the wood is likely to crack and shrink and also the fungi will attact on it easily.

OBJECTIVE/ADVANTAGES OF WOOD SEASONING Seasoning makes wood light. It become easier to paint and polish seasoned wood. Seasoned wood become stronger and more stable. Seasoned stop shrinkage of wood on drying. Seasoned wood has better electrical resistance. Seasoned wood is more safe against fungi attact .

METHODS OF SEASONING There is basically two method of seasoning. NATURAL SEASONIG. ARTIFICIAL SEASONING.

NATURAL SEASONING Natural seasoning OR Air seasoning: In air seasoning the wood is placed on each other in an open area in such way that there is a gap between wood for the air to pass between them. So by evaporation the moisture will be reduced from the wood after some days. Air seasoning can reduced moisture level in the wood to 10% to 20%.

ARTIFICIAL SEASONING One of the artificial seasoning methods is kiln seasoning . KILN SEASONING: In kiln seasoning we have a chamber which is 100% free from moisture. So we put the wood in the chamber and increase its teprature so due to the high temperature the water from the wood comes out and evaporate and the level of moisture in wood become reduced. In kiln seasoning we can control every thing like temperature and amount of moisture in wood . We can also drop the moisture level upto 0%.

COMPARISON OF AIR SEASONING(Natural seasoning) AND KILN SEASONING(Artificial seasoning) AIR SEASONING Simple and cheap. Take large area. Slow process. Hight strength. A little low quality. Moisture level can decrease to 10% to 20%. KILN SEASONING Technical and expansive. Take small area. Fast process. A little less strength. High quality and safe. As desired (moisture level can decrese upto 0%)

PRESERVATION OF WOOD DEFINITION : “All measures that are taken to ensure along life of wood is known as preservation of wood”. We use preservatives for preservation. Chemical compound that injected into the timber or wood to make it poisonous for insects or fungi without altering the structural properties of wood. preservation used for maintaining useful life of wood.

TYPES OF PRESERVATION Following are the types. OILY SUBSTANCE: Coal tar best preservative. Obtained from bituminous coal. Used to control wood degradation problem. In soluble in water hence used as permanent preservative. Highly toxic for fungi and insects.

WATER SOLUBLE PRESERVATION: Zinc chloride mainly used. Easily available, clean, odorless. Other water soluble preservatives chromatid copper assenate, acid copper chromate, ammonical copper assenate, ammonia soluble zinc copper assenate etc. SALTS: Asch is mainly used. Copper and aseric compounds used as preservative. Good fire resistant so can protect from fire.

METHODS FOR PRESERVATION OF TIMBER Methods for preservation of timber are: Timber must be fully seasoned before preservation. CHARRING: Lower ends of posts that are embaded generally charred. To prevent from rotting and worms attack. Done by quenching the ends of posts.

TARRING: Use tar for coating. Embedded portion of timber fence posts. Tarring at ends of doors and window frames. Beams can also be tarred. PAINTING: Acts as preservation. Increases the appearance of treated surface. Only well seasoned timber is painted.

THANK YOU
Tags