Wound management of burn

vanessasugarsiquian 9,434 views 36 slides Dec 21, 2013
Slide 1
Slide 1 of 36
Slide 1
1
Slide 2
2
Slide 3
3
Slide 4
4
Slide 5
5
Slide 6
6
Slide 7
7
Slide 8
8
Slide 9
9
Slide 10
10
Slide 11
11
Slide 12
12
Slide 13
13
Slide 14
14
Slide 15
15
Slide 16
16
Slide 17
17
Slide 18
18
Slide 19
19
Slide 20
20
Slide 21
21
Slide 22
22
Slide 23
23
Slide 24
24
Slide 25
25
Slide 26
26
Slide 27
27
Slide 28
28
Slide 29
29
Slide 30
30
Slide 31
31
Slide 32
32
Slide 33
33
Slide 34
34
Slide 35
35
Slide 36
36

About This Presentation

No description available for this slideshow.


Slide Content

WOUND MANAGEMENT OF BURN

burn is a type of  injury  to  flesh  or  skin  caused by  heat ,  electricity ,  chemicals ,  friction , or  radiation .

management • Assess: - Airway - Breathing: beware of inhalation and rapid airway compromise - Circulation: fluid replacement - Disability: compartment syndrome - Exposure: percentage area of burn. • Essential management points: - Stop the burning - ABCDE - Determine the percentage area of burn (Rule of 9’s) - Good IV access and early fluid replacement. • The severity of the burn is determined by: - Burned surface area - Depth of burn - Other considerations.

Classification of burn depth

Types of dressing for different degrees of burn Management of the superficial burn In the very superficial burn with no epidermal loss, no dressing will be required. These burns are very painful and a topical analgesic cream may be useful. This can be followed by the use of a moisturising cream when the pain has eased. The superficial burn can be treated by a variety of wound products. These should be chosen to protect the wound and encourage re- epithelialization . Product groups that are commonly used include Polyurethane semipermeable films, Hydrocolloids and retention dressings. If infection is present or a there is a high risk of potential for infection to occur, an antibacterial dressing should be chosen.

Management of the partial thickness burn The management of the partial thickness burn injury and the split thickness skin graft donor site is very similar. The donor site should have a low risk of infection and anti bacterial dressings are not normally required. Product groups that may be considered for this depth of burn, include: • Hydrocolloids • Polyurethane films • Biologic dressings • Biosynthetic dressings • Alginates • Polyurethane membrane supported gel • Foams • Antimicrobial products such as products containing silver.

Management of the full thickness burn Full thickness burn injuries are treated with antimicrobial dressings. The most common dressing used is Silver Sulphadiazine cream and Silver Nitrate Solution. There are now a wide variety of products containing silver available. The choice of product can be guided by the same principles of choice for any dressing. There are advantages and disadvantages to all of the Silver products. Factors to be considered in addition to those listed above, include: • Likely time to surgery (pointless to use most expensive product if it is going to be removed in a very short period of time) • Proximity of skin grafts or skin substitutes (creams may cause separation of substitutes or grafts) • Presence of escharotomy site • Access required • Temperature of patient • Availability.

Nutrition • Patient’s energy and protein requirements will be extremely high due to the catabolism of trauma, heat loss, infection and demands of tissue regeneration. If necessary, feed the patient through a nasogastric tube to ensure an adequate energy intake (up to 6000 kcal a day). • Anemia and malnutrition prevent burn wound healing and result in failure of skin grafts. Eggs and peanut oil and locally available supplements are good.
Tags